Just about all About Epoxy Garage area Ground Coatings Programs

Why have https://www.puretekllc.com/ ? Common garage flooring are just basic gray concrete. More than time, stains from grease, oils, and chemicals trigger plain gray concrete to turn into an unpleasant eyesore. Possessing an epoxy garage flooring coating will give you a long time of support, sturdiness and will resist most stains as properly as give you with a wonderfully, completed floor to preserve the value of your house.

The Most Typical Epoxy Flooring Coating Techniques

There are a few widespread systems available that will boost your garage ground:

one. Epoxy & Polyurethane Strong Shade Program

two. Epoxy Chipstone (partial vinyl chip broadcast) with Polyurethane Leading Coat Technique

three. Epoxy Granitex (100% vinyl chip broadcast) with Polyurethane Prime Coat Program

Preserve in head that with these three epoxy systems, you have ‘good’, ‘better’ and ‘best’ varieties of epoxy garage floor systems.

The Great Program

The epoxy polyurethane strong color technique will final around 5-7 years, maintenance free of charge, but will need a upkeep coat of pigmented polyurethane. This garage floor coating is normally a two-coat, thin film system ranging in thickness from four-20 mils. It is used by roller or airless sprayer.

The Much better Program

The epoxy Chipstone technique will previous around seven-12 many years, routine maintenance free ahead of needing a maintenance coat of very clear polyurethane. This epoxy garage ground method usually is made up of one particular pigmented primer coat of epoxy a pigmented shade coat with a partial/light-weight broadcast of vinyl chips into the wet epoxy and a solitary coat of very clear polyurethane for security. The thickness is roughly 20-30 mils.

The Very best Program

The epoxy Granitex technique can previous as extended as 12-fifteen+ a long time, maintenance cost-free before needing a servicing coat of polyurethane. This epoxy floor coating is typically 1 pigmented primer coat a pigmented coloration coat with a 100%/total broadcast of vinyl chips and two coats of very clear polyurethane.


Suitable floor preparing is vital to the prolonged time period success of the set up. All surfaces to be coated have to be cleaned of contaminants which may interfere with bonding. Concrete should be acid-etched, shot-blasted or diamond-floor to attain a profile related to 120 grit sandpaper. Following preparing, the concrete surface area need to be inspected for holes and cracks. If holes or cracks are widespread, then patchwork ought to be executed. Once planning is complete, set up is ready to start.

Set up of Granitex Epoxy Garage Floor System:

one. Surface area preparation, patchwork and roll one particular coat of pigmented epoxy primer.

two. After epoxy primer is dry, inspect, prep and roll one coat of pigmented epoxy in excess of primed area. Perform in 10×10 or 12×12 sections at a time. Even though epoxy is wet, broadcast vinyl chips into soaked epoxy. Be sure the spot gets 100% coverage. When all sections are totally covered, enable dry totally.

3. When all sections are dry, scrape, sweep and vacuum all extra Granitex vinyl chips from the surface area. Utilize a slim coat of polyurethane to lock and lay vinyl chips down.

4. When the polyurethane is dry, apply a 2nd coat for a closing best coat. As an alternative, non-skid resin sand can be extra to increase the slip resistance.

All epoxy garage floor coatings can be effortlessly cleaned with mild, liquid detergents then mopping, hosing or even “swiffering”. Grease, oils, and most substances will not stain or take in into the epoxy coated ground.